Step 1: Put nostril fishtail in
pliers at a 90º angle to the handle of the pliers on the side that
looks layered. Use the curve closest to the midsection of the pliers
. |
Step 2: Using the side of your
index finger, GENTLY push the nostril fishtail straight up, bending
it as close to the pliers as possible. |
Step 3: Using your thumb, curve
the nostril screw around the pliers. MAKE SURE THAT THE SCREW IS BEING
BENT EVENLY AND STRAIGHT! |
Step 4: The nostril fishtail should
look like this once bent around the pliers.
|
Step 5: Slide the nostril fishtail
off of the pliers gently, not pulling at the screw. It should look like
this "J"-shape.
|
Step 6: Take the nostril fishtail
that you have just curved into a "J"-shape. Take the curved
part and lay it against the inside of the pliers. Depending how long
you want your wearable area to be, line up the nostril fishtail similar
to this picture. |
Step 7: Closing the pliers, GENTLY
push the straight part of the nostril screw straight down (keep it straight!)
until the bend looks to be 90 degrees. |
Step 8: Look at the screw before
removing it from the pliers. Look good?
|
Step 9: Voila! You have just formed
the perfect nostril screw. Clean and enjoy!
|
) 
