| 1. Clean and dry the surface you plan on placing the
sticker. Ensure that all moisture is removed. Once applied,
water and the elements should not harm the sticker for at least
three years. |
 |
| |
|
| 2. Peel off the top layer of paper covering with the
sticker. The vinyl sticker should remain attached to the top
layer of paper, leaving a blank backing strip to throw away. |
 |
| |
|
| 3. Ensure your sticker is level, and in the location you
want, and apply it like you would a normal sticker. Place it
fully, vinyl side down, onto that clean smooth surface. |
 |
| |
|
| 4. Seal the sticker, rubbing it hard with your thumb or the
back of a spoon or the edge of a credit card to ensure it is
properly stuck to the surface. |
 |
| |
|
| 5. Grasp the corner of the paper top layer and carefully
peel it away from the vinyl cut-out sticker. This should be
relatively easy. If any of the vinyl comes up with the backing,
flatten the entire sticker out against the surface again and
press firmly along the vinyl, then attempt again. |
 |
| |
|
| 6. Show off your finished sticker with pride! If the vinyl
gets dirty, simply wipe it clean with a damp cloth. |
 |
9V6OInpBMk06emY4Q~~_11.JPG "eDecalShop")
) 
