|  |
|
|  |  | Get started in
minutes!!
Here's how it works...
The SpacePac™ cargo gate bed divider is shipped fully assembled, except for coupling the concentric tube sets. The divider is mounted inside the truck bed,
and is held in position with the force applied by two compressed* internal spring modules.
Remove the packaging, unfold, and couple the right, and left tube sets. Easily adjust the width of the
cargo gate divider assembly by sliding and locking the concentric tubes
(snap button spring). Adjust to slightly wider than the internal bed width.
To install, slightly angle the divider (inside the bed), and
*compress the upper spring tube to position. Compress and position the lower tube
set
in a like manner, then align with the upper tube set – that’s it!
Once you have adjusted your SpacePac™ cargo gate bed divider, you can position it just about anywhere in your truck bed!
Detailed instructions and illustrations for installation,
adjustment, and removal are included in the SpacePac™ user’s guide.
*This procedure requires a moderate amount of force to compress the springs. The ‘technique’ of grasping the spring shroud with both hands while
moving it slightly, and pushing forward will work for most people. With a little practice, installing and repositioning the divider becomes much easier.
| | | |
| SpacePac™ has many unique features
- Unlike other products that utilize screw out, or solid ratcheting mechanisms to hold the unit in place --
the SpacePac™cargo gate divider relies on moderate, to strong spring force to hold it in position.
There is little risk of distorting the truck bed walls, or side panels.
- When the SpacePac divider is in the full bed width configuration, there are no permanently open sections, or gaps, for the wheel wells.
For use at the wheel wells, the right and left, lower sections easily unbuckle,
swing back and attach, to allow positioning anywhere at the wheel wells.
- Both upper and lower spring modules apply the same horizontal hold, or force, at the top and bottom of the panel.
Since there is no contact with the bed floor, the divider’s stability does not rely on meshing,
or aligning with grooves in the bed floor or liner.
- Easily remove the divider, uncouple at the center, fold, and store.
- For creating multiple, divided segments in your truck bed, two or more SpacePac™
cargo gate dividers can be used.
| |  | | | |
| |
|
|
|
) 
